Siemens WM14N2G3 - Inserting the Measuring Aid for Liquid Detergent; Adding Detergent and Care Product; Starting the Programme; Changing the Activated Programme End Time

operation en
29
13.5 Inserting the measuring
aid for liquid detergent
If you order the measuring aid as an
accessory, you must use the measur-
ing aid.
1. Pull out the detergent drawer.
2. Press down on the insert and re-
move the detergent drawer.
3. Insert the measuring aid.
4. Insert the detergent drawer.
13.6 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→Page28.
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page17
3. If required, add the care product.
4. Push in the detergent drawer.
13.7 Starting the programme
Requirement:A programme is set.
→"Setting a programme", Page28
▶ Press Start / Nachlegen.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows the programme
duration or the programme end
time.
a After the programme has ended,
the display shows: "End".
13.8 Changing the activated
programme end time
You can repeatedly change the set
and activated programme end time
before starting the programme.
Requirements
¡ The programme is set.
→"Setting a programme", Page28
¡ The programme end time is set
and activated.
→"Buttons", Page22
1. Press Start / Nachlegen.
The activated programme end time
is paused.
2. Press Fertig in until the display
shows the required programme
end time.
3. Press Start / Nachlegen.
The changed programme end time
is activated.