Siemens WM14N2G3 - Soaking Laundry; Adding Laundry; Cancelling the Pro- Gramme; Resuming the Programme When the Programme Status Is Rinse Hold

en operation
30
13.9 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press Start /
Nachlegen.
3. To resume the programme, after
the desired soaking time, press
Start / Nachlegen.
13.10 Adding laundry
After the programme starts, you can
remove or add laundry depending on
the programme status.
1. Press Start / Nachlegen.
The appliance pauses.
Note:If you want to add laundry,
follow the instructions on the dis-
play.
→"Display", Page21
2. Open the door.
3. Add or remove laundry.
4. Close the door.
5. Press Start / Nachlegen.
13.11 Cancelling the pro-
gramme
1. Press Start / Nachlegen.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Spülen programme.
– If the water level is high, start
the Schleudern programme or
select a suitable programme for
draining.
→"Programmes", Page23
3. Remove the laundry.
→"Unloading the laundry",
Page30
13.12 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
Requirements
¡ Rinse Stop is activated.
→"Buttons", Page22
¡ The last rinse cycle of the set pro-
gramme has ended and the laun-
dry is in the rinsing water.
1. Set the Schleudern programme or
a programme for draining the wa-
ter.
→"Programmes", Page23
2. Press Start / Nachlegen.
13.13 Unloading the laundry
1. Open the door.
2. Remove the laundry from the
drum.
13.14 Switching off the appli-
ance
1. Turn the programme selector to
Aus .
2. Wipe the rubber gasket dry and re-
move any foreign objects.