en Additional programme settings
30
\ Additional programme
settings
Additional programme setti ngs
You can find an overview of all of the
additional settings that can be selected
depending on the programme on the
printed supplement to the installation
and operating instructions.
sensoFresh Intensity
î I, î II
The intensity of the active oxygen
treatment can be set at 2 levels:
SpeedPerfect
( Speed
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more energy
than, the selected programme, without
the SpeedPerfect setting.
Note: Do not exceed the maximum
load.
EcoPerfect
¦ Eco
Energy-optimised washing by reducing
the temperature while achieving a
washing result that is consistent with the
selected programme, without the
EcoPerfect setting.
Less iron
S
Reduces creasing thanks to a special
spin sequence followed by fluffing and
reduced spin speed.
Note: The washing's residual moisture
is increased.
Water&Rinse+
«
Adjustment values:
Higher water level and additional rinse
cycles depending on the programme,
longer programme duration for
particularly sensitive skin and/or for
areas with very soft water.
Prewash
!
For heavily soiled laundry.
Note: Pour detergent into
compartments I and II.
Rinse hold
$
If final spinning is not selected, the
laundry will remain in the water after the
final rinse.
You can select "Rinse Stop" to prevent
creasing if the laundry will not be taken
out of the washing machine immediately
after the programme has ended.
To continue/end the programme
~ Page 34
î I normal; for light odours
î II intensive; for strong odours
(cigarettes, kitchen odours)
+1 + 1 rinse
+2 + 2 rinses
+3 + 3 rinses
off Setting deselected
To Next Page
Loading...
Need help?
General
