Siemens WM14XEH5GB - Removing the Transport Struts

Installation and connection en
15
2. Unscrew and remove all four
screws for the transit bolts with a
WAF 13 wrench.
3. Pull the power cord out of the
holder.
4. Remove the four sleeves.
5. Put on the four cover caps.
6. Press down on the four cover
caps.
4.5 Removing the transport
struts
Note:Please read the information in
the Safety
→Page4 and Preventing
material damage →Page10 sections
to ensure that you use the appliance
safely.
www.devicemanuals.eu