Siemens WM14XEH5GB - Starting the Programme; Adding Laundry; Cancelling the Programme; Resuming the Programme When the Programme Status Is Rinse Hold

en Basic operation
50
1. Pull out the detergent drawer.
2. Pour in detergent.
→
"Detergent drawer", Page20
3. If required, add the care product.
4. Push in the detergent drawer.
13.7 Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶
Press Start/Reload.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
13.8 Adding laundry
Note:Please read the information in
the Safety
→Page4 and Preventing
material damage →Page10 sections
to ensure that you use the appliance
safely.
1. Press Start/Reload.
The appliance is paused and
checks whether it is possible to
add or remove laundry.
2. Add or remove laundry.
3. Close the door.
4. Press Start/Reload.
13.9 Cancelling the pro-
gramme
Once the programme has started,
you can cancel it at any time.
Note:Please read the information in
the Safety
→Page4 and Preventing
material damage →Page10 sections
to ensure that you use the appliance
safely.
1. Press Start/Reload.
2. Open the door.
The appliance door remains
locked for safety reasons if the
temperature and water levels are
high.
– If the temperature is high, start
the Rinse/Freshen Up
pro-
gramme.
– If the water level is high: Start
the Spin
or Drain programme.
3. Remove the laundry.
13.10 Resuming the pro-
gramme when the pro-
gramme status is Rinse
Hold
1. Set the Spin or Drain programme.
2. Press Start/Reload.
13.11 Unloading the laundry
Note:Please read the information in
the Safety
→Page4 and Preventing
material damage →Page10 sections
to ensure that you use the appliance
safely.
1. Open the door.
2. Remove the laundry.
www.devicemanuals.eu