37
Information on the display panel
Display Cause/Remedy
CLOSE
DOOR
– Washing may be caught. Please open and close washing
machine door again and select inicio/pausa+carga (Start/
Pause)
Ü.
– If required, shut washing machine door or remove washing and
shut again.
– If required, switch appliance off and on again; set programme
and make individual settings; start programme.
LOW WATER
PRESSURE
OPEN TAP
– Turn on tap fully.
– Supply hose kinked/jammed.
– Water pressure too low. Clean the filter. ~ Page 35
PUMP IS
BLOCKED
CLEAN PUMP
– Drain pump blocked. Clean the drain pump. ~ Page 33
– The water drainage pipe/drain hose is blocked. Clean the
drainage hose on the siphon. ~ Page 34
DOOR IS
LOCKED
Water level or temperature is too high.
Select inicio/pausa+carga (Start/Pause)
Ü to continue the
programme.
LOCKING ...
UNLOCKING ...
If the inicio/pausa+carga (Start/Pause)
Ü button is pressed too
frequently (e.g. repeatedly reloading items of washing), the door
lock may overheat. Wait for the door lock to lock or unlock.
´: ÌÍ
not applicable without AquaStop
Water in the base pan, appliance leaking.
Call customer service! ~ Page 40
ERROR
´: XXX
Switch off appliance, wait 5 seconds and switch on again. If the
display is indicated again, call customer service. ~ Page 40
To Next Page
Loading...
