Faults and what to do about them. en
53
Information on the display panel
Display Cause/remedy
Pause: Reload is not
possible
Water level or temperature is too high. Press the Ü button to continue the
programme.
Door cannot be
unlocked: Water level
or temperature is too
high
Water level or temperature is too high. Press the Ü button to continue the
programme.
The door cannot be
locked; please open
the door again, then
close it and select the
Ü button.
■ Laundry may be caught. Open and close the door again and press the Ü
button.
■ If necessary, push the door closed or remove some laundry and then push it
closed again.
■ If necessary, switch the appliance off and on again; set the programme and
make your individual settings; start the programme.
Please open tap ■ Turn on the tap fully,
■ Supply hose kinked/trapped,
■ The water pressure is too low. Clean the filter. ~ Page 51
Please clean pump ■ The drain pump is blocked. Clean the drain pump. ~ Page 50
■ The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
~ Page 51
AquaStop has been
activated! Please call
the after-sales
service
Does not occur for models without AquaStop
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service.
Auto power-off in ...
seconds,
Appliance automatically switches off after ... seconds if it is not operated for a
prolonged period. To cancel, press any button. ~ Page 47
Water cooling To protect the wastewater pipes, the hot detergent solution is cooled before being
drained.
Drum care
information:
This instruction reminds you to carry out the Drum clean 90 °C programme or a
60 °C programme to clean and care for the drum and the outer tub.
Notes
■ Run the programme without laundry.
■ Use washing powder or a detergent containing bleach. To prevent foaming,
only use half the amount of detergent recommended by the detergent
manufacturer. Do not use detergents designed for woollens or delicates.
■ Switch reminder information on/off. ~ Page 47
Other displays
Error E:XXX
Switch off the appliance, wait for five seconds and then switch it on again. If the
display appears again, call the after-sales service.
To Next Page
Loading...
Need help?
General