Siemens WM16W468DN User Manual

Positioning and connecting en
43
Before washing for the first
time
The washing machine was thoroughly
tested before leaving the factory.To
remove any water that may be left over
from the test, run the first wash cycle
without any laundry.
Notes
■ The washing machine must be
correctly installed and connected.
From ~ Page 36
■ Never use a machine if it is
damaged. Inform the after-sales
service.
Preparatory work:
1. Check the machine.
2. Remove the protective film from the
control panel.
3. Plug in the mains plug.
4. Turn on the tap.
Running the programme without
laundry:
1. Switch on the appliance.
2. Close the door (do not load any
laundry).
3. Set the Cottons 90 °C programme.
4. Open the detergent drawer.
5. Pour approximately 1 litre of water
into compartment II.
6. Pour standard washing powder into
compartment II.
Note: To prevent foaming, only use
half the amount of detergent
recommended by the detergent
manufacturer.Do not use detergents
intended for woollens or delicates.
7. Close the detergent drawer.
8. Press the Ü button.
9. Switch off the appliance at the end of
the programme.
Your washing machine is now ready to
use.

Siemens WM16W468DN Specifications

General

Appliance placement	Freestanding
Loading type	Front-load
Product colour	White
Built-in display	Yes
Control type	Electronic
Door hinge	Left
Drum material	Stainless steel
Rated capacity	8 kg
Maximum spin speed	1600 RPM
Spin-drying class	B
Washing class	A
Number of washing programs	15
Delayed start timer	Yes
Delay start (max)	24 h
Remaining time indication	Yes
Energy efficiency class	A+++
Energy efficiency class detail	A+++
Annual energy consumption washing	137 kWh
Connected load	2300 W
Current	10 A
Width	60 cm
Depth	59 cm
Height	85 cm
Weight	72 kg
Programs	Wool, Rinse, Spin