en Additional programme settings
22
After starting the programme (if a
Ready in time has been selected and
the wash programme has not yet
started), you can change the
preselected number of hours as follows:
1. Press the Ü button.
2. Use the Ready in - or + button to
change the number of hours.
3. Press the Ü button.
After starting the programme, you can
add or remove laundry if necessary.
~ Page 26
\ Additional programme
settings
Additional programme settings
An overview of all additional settings,
which can be selected depending on
the programme, can be found from
~ Page 15.
speedPerfect G
Washing in a shorter time while
achieving a washing result that is
consistent with, but uses more energy
than, the selected programme, without
the speedPerfect G setting.
Note: Do not exceed the maximum
load.
Overview of programmes ~ Page 15
ecoPerfect ¦
Energy-optimised washing by reducing
the temperature while achieving a
washing result that is consistent with the
selected programme, without the
ecoPerfect ¦ setting.
Prewash
(prelav. !)
For heavily soiled laundry.
Note: Pour detergent into
compartments I and II.
Extra Rinse
(extra l)
Additional rinse cycle for particularly
sensitive skin and/or for areas with very
soft water.
Easy-Iron
(menos Ø)
Reduces creasing thanks to a special
spin sequence followed by fluffing and
reduced spin speed.
Note: The washing's residual moisture
is increased.
Anti-Stain System
(ã)
There are four types of stain to choose
from:
The washing machine adjusts the
average washing temperature, drum
movement and soaking time to the
specific type of stain. Hot or cold water,
gentle or intensive washing and long or
short soaking ensure that the wash-
programme sequence is specially
adapted to each type of stain. This
makes sure that stains are treated in the
best possible way.
Note: Pressing and holding the buttons
automatically runs through the set
values.
ð Food-based grease/oil
ý Blood
â Red wine
ì Grass
To Next Page
Loading...
