Operating the appliance en
25
■ For safety reasons, the door remains
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
■ The load display is not active during
reloading.
Changing the programme
If you have started the wrong
programme by mistake, you can
change the programme as follows:
1. Press the Ü button.
2. Select another programme.
3. Press the Ü button. The new
programme starts from the
beginning.
Cancel the programme
For programmes at high temperatures:
1. Press the Ü button.
2. To cool down laundry: Select Rinse.
3. Press the Ü button.
For programmes at low temperatures:
1. Press the Ü button.
2. Select Spin or Empty.
3. Press the Ü button.
Programme end during rinse
hold
In the display panel, $ flashes, and the
preset spin speed and remaining
programme length are displayed for the
selected programme.
Continue the programme by:
■ Pressing the Ü button or
■ Changing the spin speed, or setting
the programme selector to Empty
and then pressing the Ü button.
Programme end
- 0 - and Ï appear in the display panel.
The Ü button indicator lamp is off.
Removing laundry/switching
off the appliance
1. Open the door and remove the
laundry.
2. Press the # button. The appliance is
switched off.
3. Turn off the tap.
Note: Not required for Aqua-Stop
models.
Notes
■ Do not leave any items of laundry in
the drum. They may shrink in the
next wash or discolour another item.
■ Remove any foreign objects from the
drum and the rubber seal – risk of
rusting.
■ Wipe the rubber seal dry.
■ Leave the door and detergent
drawer open so that any residual
water can evaporate. ~ Page 30
■ Always wait until the programme
ends, as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
■ If the display panel goes off at the
end of a programme, the energy-
saving mode is active. Press any
button to activate the panel.
To Next Page
Loading...
Need help?
General