Siemens WM16W790ES - Display Panel

en Getting to know the appliance
26
Display panel
Default programme settings:
( Temperature in °C
Ž - 90 (Ž = cold)
0
■ Spin speed in rpm,
$, 0 - 1600*;
* Max. spin speed, depending
on the selected programme
and model,
■ 0 = no spin cycle, draining only
~ Page 35,
■ $ = Rinse Stop ~ Page 35
8
■ Ready in
e.g. 2:30;
Programme duration depends
on the programme selection in
h:min (hours:minutes)
■ End time preselection
1 - 24 h;
Programme ends after ... h
(h = hours),
■ Load recommendation
e.g. kg 9*;
* depending on the selected
programme
@ Information on energy and water
consumption: ~ Page 13
■ w { { { { {
Water consumption display,
■ § { { { { {
Energy consumption display
Further information
Ù Ú sensoFresh î ~ Page 36
Programme progress:
î Active oxygen phase
! Prewash


#
¼ Wash
¬ Rinse
0 Spin
- 0 - Programme end
$ Programme end during Rinse
Stop
- P - Pause, e.g. to reload laundry
Loading door:
Ï
lights up
The washing machine door can
be opened.
Ï
flashes
When the programme has
started: The washing machine
door is not closed properly.
Tap:
|
lights up
Tap not turned on, no water
pressure
|
flashes
Water pressure too low (may
increase the programme
duration)
Childproof lock: ~ Page 39
w
lights up
Childproof lock activated
w
flashes
Childproof lock activated,
programme selector adjusted
Foam detection function:
o
lights up
~ Page 39
Fault display:
E: - - ~ Page 47
Signal setting:
0 - 4 ~ Page 41
Automatic switch-off of the appliance:
On OFF ~ Page 13, ~ Page 42
Further information