Siemens WM16XM92 - Page 45

Troubleshooting en
45
Fault Cause and troubleshooting
The appliance is not
working.
There has been a power cut.
▶
Check whether the lighting in your kitchen or other
appliances are working.
The programme does
not start.
You have not pressedStart/Nachlegen.
▶
Press Start/Nachlegen.
Door is not closed.
1. Close the door.
2. Press Start/Nachlegen to start the programme.
Childproof lock is activated.
▶
→"Deactivating the childproof lock", Page33
-Fertig in+ is activated.
▶
Check whether -Fertig in+ is activated.
→"Buttons", Page23
Laundry is caught in the door.
1. Open the door again.
2. Remove any trapped laundry.
3. Close the door.
4. Press Start/Nachlegen to start the programme.
The door cannot
beopened.
is activated.
▶
Continue the programme by selecting Schleudern
or Abpumpen and pressing Start/Nachlegen.
→"Resuming the programme when the programme
status is Rinse Hold", Page33
The temperature is too high.
▶
Wait until the temperature has dropped.
▶
→"Cancelling the programme", Page32
Water level is too high.
▶
Select a suitable programme for draining.
→"Programmes", Page25
Power failure.
▶
Open the door using the emergency release.
→"Emergency release", Page52
The water is not drain-
ing.
Drain pipe or water outlet hose is blocked.
▶
Clean the drain pipe and the water outlet hose.
Drain pipe or water drain hose is caught or jammed.
▶
Ensure that the drain pipe and water drain hose are
not kinked or trapped.
Drain pump is blocked.
▶
→"Cleaning the drain pump", Page38