Siemens WM16Y849II - Appliance Settings

Appliance settings en
35
Dosing and adding detergent:
1. Pull out the detergent drawer.
2. Add the correct dosage to
compartment À Á depending on:
– Soiling
– Water hardness (ask your water
supply company)
– The amount of laundry
– The manufacturer's instructions
3. Close the detergent drawer.
Q Appliance settings
Appliance settings You can change the following appliance
settings:
Settings that can be selected:
■ End signal
off – quiet – medium – loud – very
loud
Adjust the volume of the end signal.
■ Button signal
off – quiet – medium – loud – very
loud
Adjust the volume of the button
signals.
■ Auto power-off of the appliance
in 15 – 30 – 60 min – never
The appliance automatically
switches off after ... minutes
(= 0 kWh energy consumption); to
switch on, press the # main switch
button.
■ Language
German
English
...
Change the displayed language.
■ Info: Drum cleaning
on – off
This instruction reminds you to carry
out a drum cleaning programme.
■ Dispenser content:
i-Dos i I ô content
Fabric softener - detergent
Select/change the dispenser
content.
■ Basic dosage:
i-Dos i I ô basis
10 ml – 200 ml
Set the basic dosage in accordance
with the recommendations of the
detergent/fabric softener
manufacturer.
■ Basic dosage:
i-Dos ô basis
10 ml – 200 ml
Set the basic dosage in accordance
with the recommendations of the
detergent manufacturer.
To change the settings, press and hold
both Basic Settings 3 Sec. buttons for
approx. 3 seconds. ~ Page 13
Notes
■ The settings are retained after the
appliance is switched off.
■ If you press and hold the buttons,
the settings run through
automatically.