Siemens WM16Y890ES User Manual

64
Before the 1st washing
The washing machine was inspected thoroughly before leaving
the factory. To remove any water left over from testing
procedures, the first washing cycle should be carried out without
laundry in the machine.
²
The washing machine must have been installed and connected
properly. See chapter Installing ~ Page 62
1. Check the machine.
²
Never switch on a damaged machine. Inform your customer
service. ~ Page 51
2. Fill dispensers ô / M ô.
3. Remove protective film from the fascia.
4. Insert mains plug.
5. Turn the tap on.
6. Switch on the appliance.
7. Close the washing machine door. Do not load any washing.
8. To prevent unused detergent from flowing into the outlet
during the first wash: Pour 1 litre of water into dispenser À Á
and start the Drain programme.
9. Select and start the algodón/algodão (Cottons) 90 °C
programme.
10. When the programme ends, switch off the appliance.
Your washing machine is now ready for use.

Siemens WM16Y890ES Specifications

General

Appliance placement	Freestanding
Loading type	Front-load
Product colour	White
Built-in display	Yes
Door hinge	Left
Drum material	Stainless steel
Control type	Electronic
Capacity	9 kg
Maximum spin speed	1600 RPM
Spin-drying class	B
Washing class	A
Delay start	Yes
Delayed start (max)	24 hours
Remaining time indication	Yes
Child lock	Yes
Energy efficiency class	A+++
Energy efficiency class detail	A+++
Width	60 cm
Depth	59 cm
Height	85 cm
Dimensions (HxWxD)	85 x 60 x 59 cm
Noise Level (Spin)	74 dB
Type	Front-loading washing machine