EasyManua.ls Logo

Siemens WT47W448DN - Emptying the Condensate Container

Siemens WT47W448DN
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating the appliance en
25
3. Remove the fluff from the recess in
the fluff filter.
Note: Ensure that no fluff falls into
the open shaft.
4. Pull apart the two-part fluff filter.
5. Open both filters and remove all the
fluff.
6. Rinse away the fluff under warm,
running water.
7. Dry the fluff filter, close it and reinsert
the two-part fluff filter.
Caution!
The dryer may be damaged.
Do not operate the dryer without a fluff
filter or if the fluff filter is defective.
Emptying the condensate
container
Notes
You can drain off the condensation
into the waste-water system using an
optional condensation drain
*
.
If you drain the condensation using
an optional condensation drain, you
do not have to empty
the condensate container.
Note: After each drying cycle, empty
the condensate container; otherwise
the next drying programme may be
cancelled as a result of the condensate
container being full.
1. Pull out the condensate container
horizontally.
* Depending on the model

Related product manuals