en Signal setting
26
2. Pour out the condensation water.
Caution!
Dirty condensation water may be
harmful to your health and cause
material damage.
Condensation water is not suitable
for drinking and may be
contaminated with fluff. Do not drink
the condensation water or reuse it.
3. Push in the condensate container
until you feel it lock back into place
in the dryer.
Note: The filter in the condensate
container filters the condensation which
is used during the dryer's automatic
cleaning cycle. The filter is cleaned by
emptying the condensation.
Nevertheless, you should check the
filter regularly for remaining deposits
and remove them. See ~ Page 29.
M Signal setting
Signal setting
You can change the following settings:
■ The spin speed that is used for
spinning your laundry before it is
dried,
■ The volume of the audible signal at
the end of the programme,
■ The volume of the audible button
signals.
You will need to activate the setting
mode in order to change these settings.
Activating setting mode
1. Switch the dryer on.
2. Select the "Cottons" programme in
position 1 and wait for five seconds.
Setting mode is now activated.
The symbols go out in the display panel
and the programme duration is
displayed.
1. Press and hold the Start button and,
at the same time, turn
the programme selector clockwise
to position 2.
2. The spin speed is shown in
the display.
3. Press the "Ready in" time button
or the drying time button to change
the spin speed.
4. Turn the programme selector
clockwise to position 3.
To Next Page
Loading...
