Siemens WU14UTA8 - Adding Detergent and Care Product; Starting the Programme; Changing the Activated Ready In Time; Soaking Laundry

operation en
31
3. Fold the measuring aid down and
click it into place.
4. Push in the detergent drawer.
13.7 Adding detergent and
care product
Notes
¡ Do not use the measuring aid for
liquid detergent for gel detergents,
washing powder, or if Prewash or
"Ready in" time are activated.
¡ Observe the information about de-
tergents and care products
→Page29.
1. Pull out the detergent drawer.
2. Pour in detergent.
→"Detergent drawer", Page18
3. If required, add the care product.
4. Push in the detergent drawer.
13.8 Starting the programme
Note:If you want to change the time
until the programme ends, set the
"Ready in" time first.
▶ Press Start/Nachlegen.
a The drum rotates and load detec-
tion takes place. This can take up
to 2 minutes, after which water
enters the drum.
a The display shows either the pro-
gramme duration or the "Ready in"
time.
a After the programme has ended,
the display shows: End.
13.9 Changing the activated
"Ready in" time
If you have set and activated a
"Ready in" time for a delayed pro-
gramme start, you can change the
"Ready in" time again before the pro-
gramme starts.
Requirements
¡ The programme is set.
→"Setting a programme", Page29
¡ The "Ready in" time is set and ac-
tivated.
→"Buttons", Page23
1. Press Start/Nachlegen.
The activated "Ready in" time is
paused.
2. Press Fertig in repeatedly until the
display indicates the desired
"Ready in" time.
3. Press Start/Nachlegen.
The changed "Ready in" time is ac-
tivated.
13.10 Soaking laundry
Note:No additional detergent is re-
quired. The washing solution is then
used for washing.
1. Start the programme.
2. To pause the programme, after ap-
prox. 10 minutes, press Start/
Nachlegen.
3. To resume the programme, after
the desired soaking time, press
Start/Nachlegen.
13.11 Adding laundry
1. Press Start/Nachlegen.
The appliance pauses.