Sievert MultiTorch Spark - User Manual

MULTITORCH
INSTRUCTIONS
INSTRUCCIONES
Supplied By
ROTHERNBERGER US, INC
7130 Clinton Rd
Loves Park IL 61111
USA 55076
1
2
1
3
MultiTorch Spark MultiTorch Brass
4
ON
OFF
1
3
871902- Standard Burner Tip
872002- Standard Precision Burner Tip
872305- Flat Flame Burner Tip
872505- Power Burner Tip
884205- Ultra Precision Burner Tip
1 SAFETY INFORMATION
1.1 Ensurethatthesealingsareinplaceandingoodconditionbeforettingthegascylinder.
1.2 Never use an appliance with damaged or worn seals and never use a leaking, damaged or malfunctioning
appliance.
1.3 Alwayschangeortthegascylinderinasafeplace,ONLYOUTSIDE,awayfromanysourceofignitionsuch
 asnakedames,pilotlights,electricresandawayfromotherpeople.
1.4 Ifyouhavetocheckthegassoundnessoftheappliance,dothisoutside.Usesoapywateronly.NEVERUSE
 AFLAMETOCHECKFORLEAKS.
1.5 Iftherehasbeenaleakageyouhavetobeextracarefulandevacutethegasbyventilation.NotethatLPGas
 isheavierthanair.Thereforeitcaneasilyaccumulateintrenchesorbelowgroundlevel.
1.6 Never leave the torch unattended when lit.
1.7 Thisapplianceconsumesoxygenandmustonlybeusedinwellventilatedareas-minumum177ft³/h.Avoid
 thefumesfromuxes,lead-basedpaint,andallmetalheatingoperations.
1.8 Usetheapplianceonsafedistancefromwallsandothercombustiblematerials.Alwayschecktomakesure
 thatnointendedsurfacesormaterialsarebeingheated.Heatingasurfacemaycauseheattobeconductedto
 adjoiningsurfacesthatmaybecombustibleorbecomepressurizedwhenheated.
1.9 Becarefulwhenusingtheapplianceoutdoorsonsunnyorwindydays.Brightlightmakesithardtoseethe
 torch’same.Windmaycarrythetorch’sheatbackatyouoratothersurfacesormaterialsnotintededfor
heating.
1.10 Neverusetheappliancewhileundertheinuenceofalcohol,drugsorotherintoxicatingsubstances.
1.11 Keeptheapplianceoutofreachforchildren.
1.12 Failuretoapplytheseinstructionsmaycausepropertydamage,personalinjuriesordeath.
2. HANDLING THE APPLIANCE
2.1 Beawarethattheburnertipofthetorchcangetexceptionallyhotduringuse.Becarefulnottotouchthe
burner tip or other hot parts of the appliance during and after use.
2.2 Donotmisusetheappliance,oruseitforanythingforwhichithasnotbeendesignedfor.
2.3 Handletheappliancewithcare.Donotdrop,throw,orotherwiseabusetheappliance.
2.4 Neverattempttomodifythetorch’sconstructionandneveruseunapprovedaccessoriesorfuels.
2.5 Alwayswearprotectiveglovesandsafetyglaseswhilehandelinghotwork.
2.6 Makesurethetorchisplacedonalevelsurfacewhenconnectedtothegascylindertoreducetheriskof
 accidentaltipover.Becarefulnottopointthetorchinadirectionwhichcouldcausenearbyobjectstoignite
when the torch is set down.
2.7 Becarefulnottooverheatnearbymaterials.
2.8 Alwayshaveareextinguisherclosebywhenusingtheappliance.
2.9 Usingthetorchwithalowamecancausedamagetotheburnertube.Onlyuselowameduringlimitedtime.
2.10 Storage:Alwaysdisconnectthegascylinderfromtheappliancewhennotinuse.Storethegascylinderin
 asafe,dryandcoolplaceawayfromheat,directsunlightandoutofreachforchildrenoranyonewhohasnot
 readtheinstructions.Neverstoregascylindersinbasementsorotherplacesunderground.
3. ASSEMBLING THE APPLIANCE
3.1 Makesuretheapplianceiscoolwhenconnectingordisconnectingcylinderandotheraccessories(Fig.B).
3.2 Ensurethatthecontrolknob(1)isturnedo󰀨(turnedfullyclockwise).
3.3 Keepthegascylinder(4)uprightwhenttingittotheappliancevalve.
3.4 Placethevalveadequatelyontopofthegascylindervalve(asshowninFig.B).
3.5 Gentlyscrewthegascylinderintothevalve.Becarfeulnottotthegascylindercrossthreaded.NOTE!
Screw hand tight only. Do not over tighten or you will damage the gas cylinder valve.
3.6 Ensurethatacompletegassealhasbeenmade.Ifyouhavetocheckthegassoundnessoftheappliance,do
 thisoutdoors.Donotcheckforleakswithanakedame.Usewarmsoapywateronly,appliedtothejoints
 andconnectionsoftheappliance.Anyleakagewillshowupasbubblesaroundtheleakagearea.Ifyouare
 indoubtorifyoucanhearorsmellgas,donotattempttolighttheappliance.Unscrewthegascylinderand
 contactyourlocaldealer.
4. INTERCHANGEABLE BURNER TIPS FOR MULTITORCH BRASS
4.1 NOTE!Beawarethattheburnertipmaybeveryhotafteruse.Takecautionandwearprotectiveglovesand
 safetyglassestopreventinjuries.
4.2 Assemblyofburnertip(asshowninFig.D).Theburnertip(3)fortheMultiTorchBrasshasainterchangeable
 connection.placetheburnertipontothethreadingandturnclockwiseuntilrmlyandtightlyinplace.
4.3 Toremovetheburner,followtheinstructionsinreversedorder.
5. OPERATING APPLIANCE MULTITORCH SPARK
5.1 Pointtheapplianceawayfrombodyandammableobjects.Neverlookintotheburnertube.
5.2 Turnthecontrolknob(1)counterclockwisetoopenthevalve,pressthetrigger(2)toignitetheburner.
5.3 Toturno󰀨theappliance,turnthecontrolknobclockwiseuntilitstops.
6. OPERATING APPLIANCE MULTITORCH BRASS
6.1 Pointtheapplianceawayfrombodyandammableobjects.Neverlookintotheburnertube.
6.2 Turnthecontrolknob(1)counterclockwisetoopenthevalve,useaintstrikertoignitetheame.Neveruse
matches or a lighter to ignite the torch.
6.3 Toturno󰀨theappliance,turnthecontrolknobclockwiseuntilitstops.
7. CHANGING THE GAS CYLINDER
7.1 Shutthevalvewiththecontrolknob(1).Besuretheameisexstinguished,theburnertiphascooleddown
 andnootherameisnearby.Taketheapplianceoutdoors,awayfromotherpeople.Unscrewthegascylinder
from the valve and do not use the appliance if the sealings are cracked or worn down. Avoid cross threading
 byputtingthevalveontothegascylinderscrewthreadstraightandscrewonhandtightonly,asdescribedin
section 3.
WARNING
Thistorchisusedwithaammableproduct.Failuretocomplywiththesewarningsandinstructionsmayresultinare
orexplosionthatmaycausedamageonproperty,seriouspersonaldamageorevendeath.
Thisproductcanexposeyoutochemicalsincludinglead,whichisknowntotheStateofCaliforniatocausecancerand
birthdefectsorreproductiveharm.Formoreinformationgotowww.P65Warnings.ca.gov.
Washhandsafterusing.
2
SIEVERT® is a registered trademark of SIEVERT AB JOINT STOCK COMPANY SWEDEN.
US
ESP
US
IMPORTANT: Read these instructions carefully and familiarize yourself with the product before fitting the
appliance to the gas cylinder. Review the instructions periodically to maintain awareness. Retain these
instructions for future reference. This appliance shall be used exclusively with Sievert gas cylinders. It may
be hazardous to attempt to fit other types of gas cylinders.
BRASS
SPARK
A
B C
D E
Connection CGA 600
Gas Content 14.1 oz
Temperature 3500
o
F
221197 - Sievert MAPP Gas
Connection CGA 600
Gas Content 14.1 oz
Temperature 3500
o
F
220997 - Sievert Propane Gas

Summary

Safety Information and Precautions

General Safety Precautions and Leak Checks

Ensure good sealings, never use damaged parts, work outside, use soapy water for leak checks.

Safe Operation and Ventilation

Evacuate leaks, use in ventilated areas, keep distance from combustibles, avoid use under influence.

Child Safety and Consequences

Keep out of reach of children; failure to follow instructions can cause property damage or death.

Appliance Handling and Storage

Hot Parts and Safe Handling

Avoid touching hot parts, handle with care, use protective gear, place on level surface.

Fire Safety and Storage

Keep extinguisher nearby, avoid low flame, disconnect cylinder when not in use, store safely.

Assembly and Gas Cylinder Management

Connecting Gas Cylinder

Ensure appliance is cool, knob off, cylinder upright, screw gently hand-tight.

Leak Check Procedure

Ensure complete seal, check for leaks outdoors with soapy water.

Changing the Gas Cylinder

Shut valve, cool down, move outdoors, unscrew cylinder, avoid cross-threading.

Burner Tips and Operation

Burner Tip Assembly

Attach burner tip firmly and tightly by threading clockwise.

Spark Torch Operation

Point away from objects, turn knob counterclockwise, press trigger to ignite. Turn off by turning knob clockwise.

Brass Torch Operation

Point away from objects, turn knob counterclockwise, use flint striker to ignite. Turn off by turning knob clockwise.

Sievert MultiTorch Spark Specifications

General

Brand	Sievert
Model	MultiTorch Spark
Category	Burner
Language	English