First cover both ends of the Rudder with small pieces of scrap covering material before covering the sides. Run the end
covering "around the corner" about 1/8" onto the sides and front of the Rudder. Trim off excess.
NOTE: Always be careful when trimming excess covering material off of wood parts that you don’t "score" or cut into the
wood. Scoring a critical structural component of the airplane could seriously weaken its strength and possibly cause an in
Cover the left side of the Rudder with a
separate piece of covering material.
Run the left side covering completely
around the leading and trailing edges,
far enough so that there will be at least
1/8" overlap with the right side covering
when it is applied. Trim the side
covering flush with the top and bottom
ends of the Rudder.
To Next Page
Loading...
