.
NOTE: The edges of all the laser-cut parts have a "burnt" appearance varying from light brown to dark black, depending upon
the thickness and type of material the part is made of. Our tests indicate that a slight discoloration of the edges does not
significantly affect the bonding ability of these parts. The lightly discolored parts F2, F3, F6, MADB, and Stab L.E. Joiner can be
installed as is, without any need to try to clean the edges. However we recommend that the black edges of former F1, made of
1/4" thick plywood, be lightly sanded with an 80 grit sanding block to remove the loose black soot. It's not necessary to sand
every bit of black off (you don't want to change the size of the part). Sand until you can run your finger lightly over the edge
To Next Page
Loading...
