SDG2000X Quick Start-10
1.Counter
BNC connector. The input impedance is 1MΩ. This connector is used to accept the signal measured by the frequency counter.
2.Aux In/Out
BNC connector. The function of this connector is determined by the current work mode of the instrument.
•
Sweep/Burst trigger signal input port of external trigger.
•
Sweep/Burst trigger signal output port of internal/manual trigger.
•
Burst gating trigger input port.
•
ASK/FSK external modulation signal input port.
•
Synchronization output port. When synchronization is on, the port can output a CMOS signal with the same frequency as basic waveforms (except Noise and DC),
arbitrary waveforms, and modulated waveforms (except external modulation).
•
AM, DSB-AM, FM, PM and PWM external modulation signal input port.
3.10MHz Clock Input/Output Port
BNC connector. The function of this connector is determined by the type of the clock source.
•
If the instrument uses internal clock source, the connector outputs the 10MHz clock signal generated by the crystal oscillator inside the generator.
•
If the instrument uses external clock source, the connector accepts an external 10MHz clock source.
4.Earth Terminal
Used to ground the instrument.
To Next Page
Loading...
Need help?
General
