Sigma 6000+ - Cautions and Warnings

Cautions and Warnings
CAUTIONS
1.
2.
10.
Do not immerse in liquids.
Periodic maintenance is needed to assure all
systems are functional.
Solution spills should be cleaned up, as soon
as possible, using a damp cloth or sponge. A
cleaning disinfecting solution can be used.
Wipe the front panel and the inside of the door
and the area marked “AIR/DOWNSTREAM -
OCCL SENSOR” with water and an alcohol
rinse to remove solution spillage. Dry
thoroughly before use. Contact company for
recommended cleaning solutions.
Wipe the exterior of the pump which has been
dampened with the cleaning or disinfecting
solution and then wipe the pump with a dry.
cloth to remove any excess moisture.
ELECTRIC SHOCK HAZARD. NO USER
SERVICEABLE PARTS. DO NOT
REMOVE COVER. REFERE SERVICING
TO QUALIFIED SERVICE PERSONNEL.
FEDERAL (USA) LAW RESTRICTS THIS
DEVICE TO SALE BY OR ON THE
ORDER OF A PHYSICIAN OR OTHER
LICENSED PRACTITIONER.
CMOS electronics, used in SIGMA in fusion
"pumps, are prone to electrostatic damage.
Service technicians should follow proper anti-
static procedures when working on units.
Both the bench surface and the technician
should be properly grounded.
Before changing circuit board components,
depower the unit by unplugging it from AC
and disconnecting the (RED) battery lead.
USE ONLY LV. ADMINISTRATION SETS
THAT ARE LISTED ON THE SIGMA
COMPATIBLE SET LISTING (contact
SIGMA for listing). NOTE: Use ofany other
sets will result in inaccuracies.
Approximate battery life has not bee fully
tested for continuous operational performance
after unit returned to company for repair.
Contact company for verification.
WARNINGS
Operate 0n:115 volts, 60 Hz or internal battery
only. Use Hospital Grade earthbound outlet
for 115 volts, 60 Hz operation.
The pump should be plugged in when stored
to maintain the battery charge.
Do not use if room temperature is below 15.5%
C (60° F) or above 40° C (104° F).
DANGER - POSSIBLE EXPLOSION
HAZARD IF USED IN THE PRESENCE
OF FLAMMABLE ANESTHETICS.
Do not use pens or any, other sharp object to
actuate switches. Replace torn or punctured
membranes to assure solutions won’t
internally damage the membrane switch.
(Replacement should only be performed by
authorized personnel).
If using filter set, use only filters which state
specifically in the instructions that they may
be used with pumps. Read and follow
instructions of the filter to be used.
Replace fluid container before it permits air to
enter set tubing. If air from empty container
or other source enters set, or air is detected by
the pump, purge all air from set.
FOR CONTINIUED PROTECTION
AGAINST FIRE HAZARD, REPLACE
FUSE ONLY WITH FUSE OF SAME TYPE
AND RATING
Section.1 Page 5