Sigma 6000+ - Cleaning and Maintenance

Cleaning aud Maintenance
CAUTION:
— Always press STOP then OFF and unplug the main cord before cleaning.
一 DONOT sterilize by autoclaving or ETO gas, spray or immerse any part of the pump.
— Extended use of phenolic-based cleaners and disinfectants may cause damage to the membrane
keypad.
Clean exterior surfaces with pump in upright position. Apply cleaners with a dampened cloth per
manufacturers’ instruction and dilution ratios. Subsequent disinfection is recommended using the
same application technique. Disinfectants should remain on the pump surface. in an even, but not
dripping, film for the manufacturers’ recommended. contact time. Wipe dry or air dry after
completion of contact time period before pump reuse. Dispose of all cleaning/disinfectant materials
per Federal, State and Local regulations for infectious waste disposal. -
The following cleaners and disinfectants may be used:
— 70% to 90% ethyl or isopropyl alcohol in water.* .
一 10% bleach in water (produces 0.55% Sodium Hypochlorite) or a Sodium Hypochlorite cleaner
disinfectant such as:
Dispatch®** by Caltech Industries, Inc (1-800-234-7700
* Alcohols are flammable and should be used in a well-ventilated area.
** The selection and use of disinfectants should be used in accordance with hospital and user facility
policies. This listing is strictly provided to indicate pump material compatibility with cleaning
and disinfectant agents.
For Repair/Service, contact your local distributor or SIGMA International, LLC in the U.S.A. at 1-
800-356-3454 or (716) 798-3901.
Section 1 Page 6