Sigma 6000+ - Page 29

PROGRAM OPTIONS (CONTINUED)
.NOTE: The maximum values set apply for all operating modes (Primary, Piggyback and Program
modes).
3.3 To check or change the maximum settings, with the unit OFF, hold the #5 key down while
turning the unit ON. An audible “beep” will sound when access has been completed. Release the
#5 key. Within 5 seconds, enter code 3, 0, 3. The unit will then display “SET MAX”.
3.3.1 To check or change the maximum Rate setting, press the primary RATE key. The unit
will then display “MRAT UUU” (UUU = the present maximum rate limit). If you want
to change the present setting, enter the value using the numeric portion of the keyboard.
NOTE: The maximum Rate setting range is from 20ml/hr to 999ml/hr. To save the new
value push the RUN/STOP switch. This will store the new value in the non-volatile
memory. The unit will then “beep” and display “MRAT XXX” (XXX = new value
entered).
3.3.2 To check or change the maximum Volume setting, press the primary VOL LIMIT key.
The unit will then display “MVOL UUU” (UUU = the present maximum rate limit). If
you want to change the present setting, enter the value using the numeric portion of the
keyboard. NOTE: The maximum Rate setting range is from 50ml to 9999ml. To save
the new value push the RUN/STOP ‘switch. This will store the new value in the non-
volatile memory. The unit will then “beep” and display “MVOL XXX" (XXX = new
value entered).
3.3.3. After completing the check and/or change, press OFF.
4. Low RATE limit
5.
4.1 Standard Operation — The Rate can be set as low as 0.1mi/hr:
4.2 Optional — The lower limit can be changed to restrict the lower limit to Iml/hr. This means that
the user cannot set the Rate any lower than 1ml/hr. The user can still use the decimal in setting a
Rate larger than 1.0ml/hr (i.e. 1.1, 99.5 etc.).
4.3 To Check or change this option, with the unit OFF, hold the #4 key down while turning the unit
ON. An audible “beep” will sound indicating entry into this mode. Release the #4 key. Within 5
seconds, enter code 9, 5, 1. The unit will then display “LRAT X_X” (X.X = either 0.1 or 1.0). To
change the present setting, press 3, 0, 3. After completing the selection, press OFF. This will
store the selection in the non-volatile memory (battery backed RAM).
NOTE: The Lower Rate Limit applies for all operating modes (Primary, Piggyback and Program
mode).
PIGGYBACK/PROGRAM Enable (Disable) Option
5.1 Standard Operation — The Piggyback/Program keys can be disabled during normal pump
operations.
5.2 To access option; hole the #6 key down when the pump is turned ON. A short audio “beep” will
sound when operation is complete. The unit will display “PGBK ON” or “PGBK OFF” when
enabled or disabled.
5.3 The option can be toggled on or off by entering the key sequence 3, 0, 3 within 5 seconds of
releasing the #6 key.
5.4 “PGBK ON” ~ indicates Piggyback/Program keys are enabled.
“PGBK OFF” — indicates Piggyback/Program keys are disabled.
5.5 After completing the selection, press OFF. This will store the selection in the non-volatile
memory (battery backed RAM). .
Section 1 Page 21