possibility to pair all sensors at once or to pair single sensors. You can see which sensors have already
been connected in the “Connected sensors” area.
Some sensors provide additional information that can also be retrieved. For example, the electronic circuit
provides important information about the battery condition.
The following ANT+ / ANT sensors are supported:
– Speed sensor
– Cadence sensor
– Speed & cadence combo transmitter
– heart rate
– Power meters (PWR and CTF) – without “Cycling Dynamics”.
– Gear changes – Di2, eTap, Campa EPS
– radar
– FE-C / Smart Trainer
– remote control
– Rotor power meter – incl. display of OCA/OCP values
BLE SENSORS
If you own a sensor that transmits data exclusively via Bluetooth Low Energy, you can also connect it to
the ROX 12.1 EVO. The following BLE sensors are supported:
– Speed/Cadence
– heart rate
– Power meter
To start the search for BLE sensors, select ‘Settings/Sensor Connect/Search All -> BLE Search’.
Now only BLE sensors will be searched for. If you want to switch back to ANT+ sensor search, press
ANT+ Search.
NOTE: If your sensor supports ANT+ and BLE we recommend to use the connection via ANT+!
POWERMETER (ANT+)
Should you use a power meter, you have the possibility to perform a zero calibration here. Since each
power meter has differences in handling, read the manual of the power meter or contact the appropriate
service, if the calibration does not run as desired.
To Next Page
Loading...
