Signal Hound SM200A Configuration Guide

Windows 10 Setup
11
• Specifying a fixed IP for the network interface.
• Increasing the MTU size, (enable jumbo packets)
• Verifying remaining network parameters.
The default IP address for the device is 192.168.2.10 and uses port 51665. These instructions
assume you have not modified the default network configuration of the device.
Configuration Steps
First, you must navigate to the network settings. Start by going to the system settings and select
“Network and Internet”.

Signal Hound SM200A Specifications

General

Brand	Signal Hound
Model	SM200A
Category	Measuring Instruments
Language	English