You shall please notice that, if you do not follow the information of this Manual, the
manufactory will not assume any responsibility for the damages which will happen.
Before operation of the refrigerator
Before using the refrigerator, you shall please check the following
contents:
1. Check whether the inside of the refrigerator is dry, and whether
the air could flow freely behind the refrigerator.
2. Install 2 plastic wedges, as shown in the figure. The plastic
wedges will provide a necessary distance between the refrigerator
and the wall, in order to allow the circulation of air. (The figure is
only provided as an example, and it is possibly not completely the
same as your product.)
3. Clean the inside of the refrigerator according to the suggestions in the Chapter
“Maintenance and Cleaning”.
4. Open the refrigerator plug and insert it into a wall-type socket. When the door of the freezing
chamber is opened, relevant lamps inside it will turn on.
5. When the compressor is started, you will hear a sound. Even if the compressor does not
work, the sealed liquid and gas inside the refrigeration system will probably produce noises,
and this is normal.
6. You will probably feel that the temperature at the front side of the refrigerator rises. This is
normal. These areas are designed to maintain warm state, in order to avoid condensation.
Electric Connection
Connect this product to a grounding socket protected by a fuse of proper capacity.
Important information:
·The connection must meet national regulations.
·After installation, the plug of power cord must be within reach.
·The specified voltage must be equal to power voltage.
·Please do not use extension cable and multiple plugs for connection.
Damaged power cord must be replaced by an electrician who has corresponding
qualifications.
Do not operate this product before it is properly repaired, or it will cause the danger of electric
shock!
41
INSTALLATION
To Next Page
Loading...
Need help?
General
