SIHOO M102C - Page 5

Assembly Instructions
(Please refer to the actual size.）
Step 1
Step 2
Step 3
Step 4
Scan for
Video Guide
Use four M6X20 screws to connect the seat cushion to the mechanism, ensuring
correct front and back alignment.
Decorative
cover
Chair leg
base
First, separate the base into two pas: the decorative cover and the chair leg base.
Use 10 M6X14 screws to connect the ve chair leg tubes to the base.
Inse the wheels into the chair legs, then snap the decorative cover onto the chair legs.
Finally, inse the gas lift into the middle hole of the base.
A
N
G
B
Q
03 04
Step 5
Step 6
Step 7
Step 8
P
K
L
Inse the lumbar suppo into the backrest slot hole and tighten the lumbar suppo knob
clockwise.
Use two M6×25 screws and the armrest xing device to connect the armrest bracket and
the backrest connector. Finally, put on the armrest decorative cover. Ensure the armrest
bracket intersects with the convex cue of the backrest connector.
Use 4 M6X25 screws to connect the backrest and armrests. Use a wrench to tighten them
clockwise to 80% tightness.
Use 6 M6X35 screws to connect the seat cushion and armrests. Use a wrench to tighten
them clockwise while also tightening the screws connecting the backrest and armrest.
C
D K E
M
H