05 06
Operation Instructions
(Please refer to the actual size.)
Safety Installation
1. Each chair is designed to suppo the weight of one person only.
2. Please use the chair on a at, even suace.
3. Do not allow children under the age of 5 to sit on the chair without supeision.
4. Avoid sitting on the armrest to prevent potential accidents.
5. Do not stand on the chair, use it as a ladder, or step on it.
6. Please refrain from placing excessive weight on the chair or using it as a makeshift trolley.
7. Avoid using sharp or pointed objects that could damage the chair, and keep it away from
open ames or sources of heat.
8. For your safety, do not attempt to disassemble the gas lift mechanism.
Step 9
Step 10
Align the headrest with the holes on the upper pa of the backrest, and use 2 M6X25
screws to install the headrest. Use a wrench to tighten them clockwise, and nally install
the headrest decorative cover.
Align the assembled upper pa of the chair with the gas lift and inse it.
The armrests can
slide forward and
backward, as well
as rotate left and
right.
The rotating spring
knob adjusts the
reclining force.
The seat can rotate
360°.
The headrest can be
adjusted up and down,
as well as forward
and backward.
The lumbar suppo
can be adjusted up
and down.
Height adjustment:
When sitting in the
chair, lift it to lower
the chair. When not
sitting in the chair,
lift it to raise the chair.
To control the tilt, push
or pull the right-side
lifting rod of the base.
R
K
To Next Page
Loading...
