03 04
Assembly Instructions
(Please refer to the actual size.）
Use four mechanism screws (M6X20) and four 8mm washers to connect the base
and the seat.
Place the seat upside down on the packaging cardboard and inse the chair back
into the rear plate.
Utilize four chair back attachment screws (M8X20) to connect the chair back to the rear
plate. (Secure the screws near the outer side of the rear plate, as indicated in the diagram.)
Step 1
Step 2
Step 3
Inse two armrest brackets into the mechanism.
Secure the armrest brackets to the chair back using four armrest bracket screws
(M6X25) and four 6mm washers.
se ten (M6X12) chair leg screws to connect the ve chair leg tubes to the base,
and then inse the wheels.
Step 4
Step 5
Step 6
Scan for
Video Guide
F
D
B
G
C
A
I
H
M
E
N
L
J
K
To Next Page
Loading...
