Siko MSK320 - Page 9

MSK320+MB320,MRI01,MR320,MRF320 Datum 23.11.2009 Art.Nr. 80353 Änd. Stand 350/09 9
Metalflange
0.1mm ... 2.0mm
Magnet
< 3°
Signal
A before B
Direction of rotation
of magnetic ring
Undercut at the
solid shaft for
tread plug is re-
commended
Fig.6: Definition of the counting direction with ma-
gnetic ring and assemblage sensor/magnetic ring,
gap measure, tolerances
0.1mm ... 2.0mm
< 3°
Signal
A before B
Direction of rotation
of magnetic ring
< 3°
Un de rc u t
at the solid
shaft for
tread plug
is recom-
mended
Admissable deviation
middle of tape/sensor:
without ref. point ±2mm
with ref. point ±0.5mm
Signal
A before B
Direction of rotation of magnetic ring
0.1mm ... 2.0mm withput reference point 0.1mm ... 1.0mm with reference point
reference
point
Direction of outgoing cable
< 3°
Fig.7: Definition of the counting direction with
magnetic strip and assemblage sensor / magnetic
ring, gap measure, tolerances
<3°
0.1 ... 2.0mm
Signal
A before B
Travel direction
arrow
0.1mm ... 2.0mm wit- hout reference point 0.1mm ... 1.5mm with reference point
Gap sensor/magnetic strip
< 1°
< 3°
active
side
Travel direction
Direction of
outgoing cable
Signal
A before B
Maximum alignment error
< 3°
Position of the reference point relating
to the marking on the magnetic strip
Admissable deviation
middle of tape/sensor:
without ref. point ±2mm
with ref. point ±0.5mm
Position of the reference point P = as
staded in the delivery documentation
Position of the reference point E = as staded
in the delivery documentation; min. 0,032m
Magnetic poles
- schema
Unique reference point
Periodical reference point
MSK320 design F with MRI01 or MR320:
MSK320 design F with MRF320:
RADIAL application:
MSK320 design A with MRI01 or MR320:
LINEAR application:
MSK320 design A with MB320:
MSK320 design F with MB320: