Silca Air4 - Page 6

Air4 Universal Receiver
Copyright Silca S.p.A 2020. All right reserved
6
English
ADVANCED FUNCTIONS AND TROUBLE SHOOTING
How to insert the buon of an Air4 V remote control back into the Universal Receiver.
This procedure is necessary if:
- The used Air4 V remote control has been lost / broken
- The buon associated with the Air4 Universal Receiver was mistakenly overwrien with another
remote control
Procedure:
• Press buon ‘P’ on the Air4 Universal Receiver for a few seconds unl LED 1/2 ashes; release buon
‘P ’.
Note: With LED L1 on (relay 1 output) press buon ‘P’ to select LED L2 (relay 2 output).
Press the free buon on the AIR4 V remote control (with soware version equal to or above 1.6) unl
LEDs ‘L1’ and ‘L2’ illuminate with a xed light.
• Release the remote control buon.
• When LEDS ‘L1’ and ‘L2’ go out, the AIR4 V buon has been memorised on the receiver.
How to make other copies of a remote control
To make a copy of the Air4 Universal Receiver code (e.g. buon 1) on other remote controls, use a Silca
AIR4 V remote control (with soware version equal to or above 1.6) and follow Silca’s standard copying
instrucons.