Silca Air4 - Page 7

Air4 Universal Receiver
Copyright Silca S.p.A 2020. All right reserved
7
English
COPY PROCEDURE
1. PLACE THE REMOTE CONTROL TO BE CLONED IN FRONT OF THE “AIR4”, AT A DISTANCE OF ABOUT 2 CENTI-
METRES
2. PRESS AND HOLD DOWN BUTTON 1 ON THE “AIR4” REMOTE CONTROL
3. AT THE SAME TIME PRESS BUTTON 4 FOUR TIMES.
4. RELEASE BOTH BUTTONS OF “AIR4” REMOTE CONTROL.
5. “AIR4”REMOTE CONTROL LED WILL FLASH BRIEFLY ABOUT EVERY 2 SEC.
6. PRESS AND HOLD DOWN THE BUTTON TO BE COPIED FROM THE ORIGINAL REMOTE CONTROL AND WAIT FOR
THE “AIR4” LED TO START FLASHING RAPIDLY, WHICH CONFIRMS THAT THE CODE HAS BEEN ACQUIRED. RELEASE
THE ORIGINAL REMOTE CONTROL’S BUTTON.
7. WHILE THE LED IS FLASHING, PRESS THE “AIR4” BUTTON TO WHICH THE CODE MUST BE TRANSFERRED AND
HOLD DOWN UNTIL THE LED GOES OUT.