Osiris-Jaegar – Installer Guide
Environmental X and Environmental Y - These control the position of the internal (PCB)
Temperature/Humidity information on the screen. Setting the X value to 0 will hide the text.
Which Camera X and Which Camera Y – These set the position of the indicator of when Primary or
Secondary camera control is selected. When this is displayed, the CAM2 caption (Preset-9) is not shown
when camera control is changed. Setting the X value to 0 will hide the text, (CAM2 caption will be enabled).
Tours
A Position tour is a collection of one or more preset positions that the camera will be instructed to visit in
sequential order. Up to 16 tours can be defined and each can contain up to 60 preset positions, placed in
any order.
A Mimic tour (4 available) stores a record of the camera's pattern of movements for a period of up to 5
minutes each.
Select tour…
01@ 02 03 04
05 06 07 08
09 10 11 12
13 14 15 16
M1@ M2 M3 M4
Position Tours
The ‘@’ suffix indicates that the corresponding tour has been programmed. When you select a tour number,
you will see an options screen for that tour:
Osiris Open Platform
Version n.nnn (xxxx) xx
SN: FFFFFFFF POST: 000000000
Run tour
Edit/record tour
Erase tour
Exit menu
• Run tour – runs the current tour.
• Edit/record tour – allows a tour to be edited in a sub-menu - see below.
Erase tour – removes the tour from the camera memory.
Silent Sentinel SilSen DN145003 - 1.2b (Fork)
12
To Next Page
Loading...