Osiris-Jaegar – Installer Guide
Miscellaneous
Osiris Open Platform
Version n.nnn (xxxx) xx
SN: FFFFFFFF POST: 000000000
>Date and time
Debug messages Off
>Diagnostics
Hide quick menu Off
Idle func (tour) 0
Idle timeout 5
IR Lamp Auto-On Auto
POST 2
Return to Off-pos On
PTZF Timeout 30
Z-dependent speed On
Focus speed 60
Change password
Exit menu
Default values shown. Scroll downwards to view further items.
>Date and time sets the date and time for the cameras real-time-clock display.
Debug messages controls the display of additional information on the OSD which can help to diagnose
camera problems.
>Diagnostics displays hardware diagnostic information for factory and servicing purposes.
Hide quick menu allows you to prevent access to the Quick Menu using Preset 198.
IR Lamp Auto-on, when set to Auto, allows an optionally fitted LED illuminator to be switched on
automatically in low light conditions. When set to On or Off the lamp is in a permanent state.
Idle func (tour) selects which tour will be initiated if the idle time-out period elapses. Selecting Zero disables
the function.
Idle timeout sets the wait period from the last operator input until the Idle function is automatically started.
POST controls whether a power-on-self-test is performed at start-up. If turned off, some functions will no
longer be available. The speed of the test can be selected (for reading messages) with values 1 - 3.
Return to Off-pos controls the camera behaviour after a power-loss. If this option is on then the camera will
automatically return to the previous position.
PTZF Timeout sets a time period (seconds) after which, if no telemetry is received, any Pan, Tilt, Zoom or
Focus actions will be stopped. This is to reduce runaway when telemetry messages may be lost in
transmission.
Z-dependent speed enables the pan and tilt speed to be dynamically adjusted to match the zoom setting of
the lens – the camera will pan and tilt slower when zoomed in and faster when zoomed out.
CAM1 sets the speed by the Primary camera's zoom value.
FollowV sets the speed by the camera that is selected on the principle, video output No.1.
FollowC sets the speed by the zoom of the camera that the camera control (Primary/Secondary) has
seleceted. (In some configurations this will be the same as FollowV)
Focus speed sets the nominal rate of focus movement, (applies to specific lens versions only).
Change password allows you to alter the six digit password used to protect the setup menu. (Def: AAAAAA)
Silent Sentinel SilSen DN145003 - 1.2b (Fork)
9
To Next Page
Loading...