10 Silhouette Mint: using your custom stamp maker
Assembling the Stamp
Once printed, bend the sheet holder of the printed stamp sheet along its
perforated line (A). Carefully remove the stamp (B).
When you remove the stamp from the sheet holder, the transparent cover
attached to the sheet holder may adhere to the stamp. If this happens,
carefully remove the transparent cover, taking care not to damage the stamp.
IMPORTANT: Do not cut the stamp sheet with scissors, or any other
implement. Take care not to scratch the printed surface.
Slide the stamp mount into the stamp base until it clicks into place (C).
Remove the protective liner from the stamp mount and carefully position
your printed stamp onto the mount (D).
A B
C D
To Next Page
Loading...