Need help?Do you have a question about the Silhouette Momentum Series and is the answer not in the manual?
General| Brand | Silhouette |
|---|---|
| Model | Momentum Series |
| Category | 3D Glasses |
| Language | English |
Technical specifications for standard glazing using BLS 58, suitable for lenses with a thickness of 2.0-6.5 mm.
Technical specifications for glazing very thick lenses using BLS 98, for lenses with a thickness of 6-9.5 mm.
Technical specifications for glazing very thin lenses using BLS 97, for lenses with a thickness of 1.3-3 mm.
Use a demounting tool to partially remove the pin, then use tweezers or pliers to remove it.
Carefully remove the inner plastic part using a 1mm drill, starting from the bottom up.
Break glue bond with pliers and carefully pull off the temple cover.
To Next Page
