SiliconDust HDHomeRun TECH - Static IP Assignment; Reverting to DHCP; Channel Map Configuration

Static IP assignment:
A static IP address can be configured using the following command (the quotes are required as
shown):
Format: hdhomerun_config <old ip> set /sys/ipaddr “<new ip> <subnet> <gateway>”
Example: hdhomerun_config 169.254.34.98 set /sys/ipaddr “10.10.20.43 255.255.255.0 10.10.20.1”
Note: The TECH requires a gateway when used to stream multicast, even if on the same subnet.
Reverting to DHCP:
The HDHomeRun TECH can be configured for DHCP operation (default) using the following
command:
Format: hdhomerun_config <old ip> set /sys/ipaddr dhcp
Example: hdhomerun_config 169.254.34.98 set /sys/ipaddr dhcp
Setting the channel map:
The channel map is a non-volatile configuration option that is used to set the channel to frequency
table, to configure the channel scan table, and to optimize the auto-modulation detection.
GUI: The channel map can be set for each tuner by running HDHomeRun Config (GUI).
Command line: The channel map can be set for each tuner using the following command:
Format: hdhomerun_config <ip|id> set /tuner<n>/channelmap <channelmap>
Example: hdhomerun_config 10001000 set /tuner0/channelmap us-cable
Example: hdhomerun_config 10001000 set /tuner1/channelmap us-cable
Channel maps supported by HDHR-TECH-US hardware:
Name Description Location
us-bcast Digital Antenna (ATSC). US, Canada
us-cable Digital Cable - Normal frequency layout. US, Canada
us-hrc Digital Cable - HRC frequency layout. US, Canada
us-irc Digital Cable - IRC frequency layout. US, Canada
Channel maps supported by HDHR-TECH-EU hardware:
Name Description Location
au-bcast Digital Antenna (Australia). Australia
au-cable Digital Cable (Australia). Australia
eu-bcast Digital Antenna (Europe). Europe, New Zealand
eu-cable Digital Cable (Europe). Europe, New Zealand
tw-bcast Digital Antenna (Taiwan). Taiwan
tw-cable Digital Cable (Taiwan). Taiwan