7. Place the treatment surface (#2) on the skin and press the
pulse button (#1) to deliver one pulse. Make sure your
hand touches the base electrode (#7) together with the
pulse button (#1).
Z If you do not make hand contact with the base electrode
(#7), no galvanic treatment circulation will be emitted.
8. Press the pulse button (#1).
y The device first determines the skin color. If the skin
color is light enough for safe application, the device
will activate the galvanic circulation. You might feel
a slight tingling sensation. This is completely normal.
The galvanic treatment works to enlarge your pores
for a better application of the treatment.
y Directly afterwards, the device will flash a pulse of
light onto your skin, and the ready/skin tone warning
indicator light (#6) will turn off. You will see a bright
flash of light and simultaneously hear a popping
sound, which is a normal noise for the device. You
will feel a mild sensation of warmth and tingling. The
device will immediately recharge for the next pulse.
y After a few seconds the ready/skin tone warning in-
dicator light (#6) will turn on again and start blinking
slowly when pressed against the skin.
9. Remove the treatment surface (#2) from the treated area
of skin.
10. Decide if you wish to treat the area by Gliding or Pulsing
(see section 5.4 Pulsing and gliding).
y If you are Pulsing, place the treatment surface (#2)
on an adjacent part of your skin, and trigger a pulse.
y If you are Gliding, hold the pulse button (#1) down
continuously and slide the device smoothly along
the treated area.
EN
18
To Next Page
Loading...
