“A light pulse is
not emitted when
I press the
PULSE
BUTTON
”
• Check the
REPLACE CARTRIDGE
INDICA
TOR LIGHT
. If it is on, disconnect Silk’n
Flash&Go™ and replace the
DISPOSABLE
LAMP CARTRIDGE
.
• Make sure that the
READY INDICATOR
is on.
• If within 10 seconds the
READY INDICA
TOR
remains off turn Silk’n Flash&Go™
off and back on by pressing the
ON/
STBY SWITCH
twice.
• Check the
SYSTEM WARNING INDICATOR
LIGHT
.
• If the light is on turn Silk’n Flash&Go™
off and back on by pressing the
ON/STBY
SWITCH
twice.
• If the problem persists, contact your lo
cal Silk’n™ Customer Service Center.
To Next Page
Loading...