To Next Page
M
Mason WilsonJul 28, 2025
What to do if my SILKN Flash&Go Epilator doesn't emit a light pulse?
- WWhitney BakerJul 28, 2025
If your SILKN Flash&Go™ epilator isn't emitting light pulses when you press the pulse button, here are a few things to check: * **Replace Cartridge Indicator:** If the REPLACE CARTRIDGE INDICATOR LIGHT is illuminated, disconnect the device and replace the DISPOSABLE LAMP CARTRIDGE. * **Ready Indicator:** Ensure that the READY INDICATOR light is on. * **System Warning Indicator:** Check the SYSTEM WARNING INDICATOR LIGHT. If it's on, turn the device off and then back on again by pressing the ON/STBY switch twice. * **Ready Indicator Timeout:** If the READY INDICATOR remains off after 10 seconds, turn the device off and back on by pressing the ON/ STBY SWITCH twice.
General