PC SYNC
START?
Transfer Data from the ADC to PC
!
!
!
!
The ADC is equipped with a function to
transfer/backup the data from the ADC to
PC.
To be able to transfer data to a PC, the
accessory ADC-IR (optional extra) is
needed.
Following the previous 'Data Log Mode
Setting Sequence' to select the PC
Synchronization Display.
In the above PC Synchronization Display,
press the [set] button once to activate the
synchronization. The data of the ADC will
send to the target PC.
Note:
Start the PC's communication software prior
to the transmission.
Check the PC's hardware and software
manual for the detail on how to transfer and
receive data via infrared device.
Make sure that the infrared port (of the ADC)
is pointing towards the target ADC IR
infrared port during the transmission.
!
!
!
Data Log Mode - PC Synchronization15.5
Infrared Port
Pointing this port towards
the ADC-IR connected
toaPC
PC Synchronization
Ready Sending
[set]
if the send
completed
PC SYNC PC SYNC ...
START? STOP?
To Next Page
Loading...
Need help?
General
