Silva ADC Wind - Setting Race Timer Mode

9.1 Race Timer Mode - Setting the Race Timer Mode
To Select the Setting Display
Setting Sequence
!
!
!
!
!
Setting the target time in Race Timer Mode,
press and hold the [mode] button for about 2
seconds to select the setting display (the
second digits will start flashing).
In setting display, press the [mode] button to
move setting following the adjacent diagram.
When the one of the settings (second, minute,
hour) start to flash, press the [set] or [reset]
button to scroll through the settings (hold down
the button to scroll at a faster pace).
When the setting finished, press and hold the
[mode] button for about 2 seconds to exit the
setting sequence.
The setting display will change to Race Timer
Mode automatically if no key-stoke has been
activated for about 1 minute.
Race Timer Mode
RACE TIMER
0:10.00
scroll the
setting by
decrement of 1
scroll the
setting by
increment of 1
Minute
Hour
Second
hold
[mode]
hold
[mode]
[mode]
[mode]
scroll
the setting
faster
scroll
the setting
faster
[set]
[reset]
hold
[set]
[mode]
hold
[reset]
Race Timer Mode
Setting Sequence
scroll through
the settings by
increment
scroll
the setting at
a faster pace
scroll through
the settings by
decrement
scroll
the setting at
a faster pace