japa 315+ User manual
Translation 2 315+ 2.0 - 2020
1.5 The machine’s type plate
The machine’s type plate is located behind the machine, on the right side of the splitting groove.
The machine’s type plate (1)
• Serial number
• Machine type
• Production year and date
• Weight of the machine
• Voltage (machine equipped with an electric motor)
• Maximum RPM of the power take-off
• Maximum hydraulic pressure
• Diameter of the cutting blade/blade opening
• Name and address of manufacturer
1.6 Machine models
JAPA 315 BE PLUS 5.6 t Combustion engine drive
JAPA 315 E PLUS 5.6 t Electrical drive
JAPA 315 TR PLUS 5.6 t Tractor drive
JAPA 315 TRH PLUS 5.6 t Tractor hydraulics drive
JAPA 315 ROAD PLUS 5.6 t Road traffic equipment
JAPA 315 OFFROAD PLUS 5.6 t Off-road equipment
Standard equipment in all models:
• 13” hydraulic chainsaw and separate chain lubrication system
• In-feed conveyor
• Splitting system with a 4-way knife.
• The available options for log removal are a discharge chute and a 2.3 m or 3.8-m-long
hydraulic out-feed conveyor with a winch.
1.7 Safety instructions
These safety instructions are general in nature. When handling the machine, you must take into
account all other relevant instructions concerning health and safety, road traffic regulations regarding
transportation, as well as the provisions of general legislation. Observing the instructions helps to
prevent accidents.
The machine may only be used by persons who have familiarised themselves with the manual and the
operation of the machine. The operator must not be under the influence of alcohol or narcotic
substances. The requirements placed on the operator, as well as the minimum age of 18 required to
operate the machine, must be taken into account.
Study the machine’s safety and installation instructions carefully, along with the operation and control
functions, before installing and operating the machine.
General provisions:
• The machine has been designed solely for making firewood.
• The machine is intended to be used by one person at a time.
• Ensure that no unauthorised persons are in the working area. The danger zone is 10 m.
• Always check the condition of any possible power cables.
• Always use approved eye and ear protection.
• Clean and maintain the machine on a regular basis.
• Always stop the machine before maintenance and, if the machine is tractor-driven (TR), disconnect the
cardan shaft. If the machine features an electrical drive (E), disconnect the power cable.
To Next Page
Loading...