OPERATION INSTRUCTION
Before attempting to operate or install this unit carefully
read and take note of the following safety warnings.
Failure to comply with these warnings may result in serious
injury or death.
This turns the cooler on or off.
This activates the cooling function. Note that there is a
delay of one minute before the fan starts while the
cooling pads wet up.
When COOL is pressed again, the water evaporation
feature is turned off, with only the fan operating.
Pressing SPEED will select low, medium or high fan
speed.
This activates/deactivates swing function.
The timer setting can be used to start the cooler after a
certain number of hours delay. When only the green
POWER light is on, press TIMER until the number of
hours delay (1-24) is shown.
When the cooler is already going, press timer to set the
number of hours (1-24) until the machine will
automatically switch off.
Use only clean, fresh water.
Pour water into the water inlet on the right-hand side of
the unit (Do not overfill beyond max capacity).
Alternatively, attach a hose to the water inlet on the left
side for automatic filling. Note a pressure reducing valve
is recommended for high pressure water supplies.
1. All electrical repairs must only be carried out by a suitably qualified electrician,
after all power is disconnected.
2. This cooler is not intended for use by children or persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge.
3. Children should be supervised to ensure that they do not play with the
appliance.
To Next Page
Loading...