12
Operating the bumper bar.
11.1 The bumper bar on the Sleepover
seat unit can be removed for easier
access or cleaning. Press the button
underneath each side of the bumper
bar and simultaneously pull the
bumper bar out from the body arms.
11.1
12.1
Fitting the Footmu.
12.1 Your Sleepover is supplied with a
high quality footmu. Before tting,
unfasten the harness, then feed the
shoulder and crotch straps through
the button holes on the footmu.
The top of the back section will fasten
to the seat unit with a Velcro tab,
which will hold it in place.
The front section of the footmu has
two tting operations.
The front panel can be folded over
the bumper bar and held in place
with the internal magnets or fully
removed, leaving the eece seat liner
in place.
To Next Page