Silver Peak UNITY EdgeConnect - Approve Discovered Appliance in Orchestrator; Appliance Discovery and Approval Workflow; Configure Appliance Manager Settings; Configuration Wizard Steps

© 2015 Silver Peak Systems, Inc. PN 200907-001 Rev A
1
Approve the Discovered Appliance
After you power on the EdgeConnect appliance, it automatically registers its serial
number with the Silver Peak Cloud Portal. The portal knows how to associate a
serial number with a particular account.
a. Go to the Orchestrator.
b. In the header, click the blinking box named Appliances Discovered.
The Discovered Appliances page opens, listing the most recently discovered
appliances rst.
c . After verifying that the appliance is yours, click Approve.
A pop-up box appears, enabling you to assign the appliance to a group.
d. Select the group and click Apply.
The Appliance Manager Conguration Wizard opens.
2
Complete the Appliance Manager Conguration Wizard
a. Click Next. On the License & Registration page, enter your Account Name and Account Key.
If you’ve also purchased EdgeConnect Boost or EdgeConnect Plus, and you want to apply it to
this appliance, select the relevant check box(es).
b. Click Apply. It may take up to two minutes to register the appliance.
c . Complete the remaining wizard screens.
• On the Deployment page’s default conguration, the WAN–side interfaces use DHCP IP
addresses, unless you manually enter static IP addresses.
Before You Begin
 Make sure that Orchestrator is
installed and registered.
 Verify that you’ve received the
email containing your Account
Name and Account Key.
UNITY
EdgeConnect
Quick Start Guide
Part 2 - Registration
Silver Peak Systems, Inc.
2860 De La Cruz Blvd
Suite 100
Santa Clara, CA 95050
1.877.210.7325 (toll-free in USA)
+1.408.935.1850
www.silver-peak.com/support