Do not place iron upright direction when not in use. (See following figure)
1. After iron temperature is sufficiently heated, open water tank valve, and
press the steam switch. (Press for 1~2 seconds and pause for 3~4 seconds.
Repeat, pressing 1~2 seconds then resting 3~4 seconds.)
Press the steam switch this way when you need steam.
2. Start ironing.
3. Do not press steam switch continuously longer than 5~6 seconds for a proper steam function.
4. Select the number of temperature control knob according to corresponding
temperature/ clothes which is following:
# 1, 2 --------- Pre-heating
# 3 ----------- Silk or sensitive clothes (low temperature)
# 4 ----------- Cottons and wool (medium temperature)
# 5 ----------- Other thick clothes (high temperature)
5. Cover ¡°Iron Shoe¡± to iron to get a better ironing effect without glossy to the clothes after ironing.
6. Please keep flammable materials away from the iron during ironing because temperature
of iron plate is very hot (over 200℃). Also, place the iron over silicon plate when not in
7. Always remove the power plug from socket when not in use.
of iron plate is very hot (over 200℃). Also, place iron over silicon plate when not in use.
8. Always remove power plug from socket when iron is not in use.
Problems Check Points Corrective Actions
Iron does not work at all
♧ Is power plug is connected to power socket?
♣ Connect power plug
♧
Is main switch turned on? ♣ Turn on main switch
Steam does not come out
♧
Is there water in water tank? ♣ Fill water to the water tank
♧
Is water tank valve opened? ♣ Turn water tank valve
counter clockwise
♧
Is silicon hose twisted or clogged? ♣ Release twist or remove
clogged materials
Steam pressure is weak
♧
Is water tank valve fully opened? ♣ Fully open water tank valve
♧
Is steam hole clogged? ♣ Unclog steam hole
Water flows out
♧
Does temperature control knob ♣ Adjust tempera control
indicate too low temperature? knob to higher temperature
♧
Is steam switch pressed too long ♣ Press steam switch only
(more than 10 seconds) 1~2 second
Steam comes out when
switch is not pressed
♧
Is steam switch out of order?
♣ Contact head office or A/S
centers
♧
Is rubber packing inside solenoid
valve wore out?
3
To Next Page
Loading...