EasyManua.ls Logo

Silver 4Bmini - Specifications

Silver 4Bmini
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SILVER Audio Processor 4Bmini Users manual
Page 36/38
Audemat-Aztec SAAudemat-Aztec INC
web: www.audemat-aztec.com - e-mail: contact@audemat-aztec.com
Specifications
Specifications apply for measurements from analog left/right input to stereo composite output.
Frequency Response (Bypass Mode):
Follows standard 50µs or 75µs pre-emphasis curve ±0.10 dB, 2.0Hz–15kHz.
Noise:
Output noise floor will depend upon on the processor settings but is governed by the dynamic range of the
A/D Converter. The dynamic range of the digital signal processing is 144 dB.
The unit can interface with 600 devices and is therefore compliant with 600 input requirements.
Processing Sample Rate:
48kHz - 768kHz depending on processing stage.
Processing Resolution:
Internal processing has 24 bit (fixed point) or higher resolution.
Analog Audio Input
Configuration:
Stereo
Impedance:
>10k. load impedance, electronically balanced
Nominal Input Level:
Software adjustable from –4.0 to +8.0 dBu (VU).
Maximum Input Level:
+24 dBu or +12 dBu, depending on the internal jumper settings
Connectors:
XLR female Pin 1 chassis ground, Pins 2 (+) and 3 electronically balanced, floating and
symmetrical.
A/D Conversion:
48 KHz 24 bit 128x oversampled delta sigma converter with linear-phase anti-aliasing filter.
Filtering:
RFI filtered.
Digital Audio Input
Configuration:
AES/EBU Stereo, 24 bit resolution, software selection of stereo, mono from left, mono from right
or mono from sum.
Sampling Rate:
32, 44.1, 48, 88.2, or 96 kHz, automatically selected.
Connector:
XLR female. Pin 1 chassis ground, pins 2 and 3 transformer balanced and floating, 110 ohm
impedance.
Filtering:
RFI filtered.
MPX output
Source Impedance:
10 Ohm Single-ended, floating over chassis ground.
Load Impedance:
600 Ohm or greater.
Maximum Output Level:
+12.0 dBu (peak) software-controlled output level control
Minimum Output Level:
0dBu (peak)Software-controlled output level control
Pilot Level:
Adjustable from 6.0% to 12.0% and OFF, software controlled.
Pilot Stability:
19 kHz, ±1 Hz (10 degrees to 40 degrees C).
D/A Conversion:
24-bit
Signal-to-Noise Ratio:
<= –85 dB (Bypass mode, de-emphasised, 20 Hz – 15 kHz bandwidth.
Distortion:
<= 0.02% THD (Bypass mode, de-emphasised, 20 Hz – 15 kHz bandwidth.
Stereo Separation:
Typ. > 70 dB 30 Hz - 15 kHz.
Crosstalk-Linear:
<= –80 dB, main channel to sub-channel or sub-channel to main channel.
Crosstalk-Non-Linear:
<= –80 dB, main channel to sub-channel or sub-channel to main channel.
38 kHz Suppression:
>= 70 dB.
76 kHz & Sideband Suppression:
>= 80 dB.
Connectors:
BNC, floating over chassis ground
Filtering:
RFI filtered.