1. Hold the upper thread with the left
hand. Turn the handwheel towards
you (counterclockwise) lowering, then
raising the needle.
2. Gently pull on the upper thread to
bring the bobbin thread up through the
needle plate hole. The bobbin thread
will come up in a loop.
3. Pull both threads to the back under the
presser foot.
Raise the presser foot. Remove the
fabric, draw the threads to the left side of
the face cover and cut using the thread
cutter.
The threads are cut at the proper length
to start the next seam.
20
To Next Page
Loading...
